Where should the tractor be when you inspect landing gear after uncoupling the trailer?

While driving behind another vehicle under the good condition you should allow at least one second between your vehicle and the vehicle ahead for each _______ (how many) feet of your vehicle length?

There are two things that a driver can do to prevent a rollover. They are: (1) keep the cargo as close to the ground as possible; and (2):

The air brake leakage rate for a combination vehicle (engine off, brakes off) should be less than ___ psi per minute.

The safest way to make turn without entering another traffic lane is:

The higher the center of gravity of your truck, the:

If the service line cornes apart while you are driving a combination vehicle but the emergency line stays together, what will happen right away?

Glad hands are usually connecting which of these?

A driver crosses the air lines when hooking up to an old trailer. What will happen?

The hand valve should be used:

When driving a set of doubles it is necessary to close which shut-off valve in the last trailer.

If the service line comes apart while you are driving a combination vehicle but the emergency line stays together, what will happen right away?

You are about to back your tractor under a semitrailer. The trailer is at the right height when the:

Your emergency air line breaks or gets pulled apart while you are driving. The loss of pressure will cause the:

If the brakes are not released when you pushed the trailer air supply valve you should:

Air brake equipped trailers made before 1975:

There are two things that a driver can do to prevent a rollover. They are: (1) go slow around turns; and (2):

After connecting the air lines but before backing under the trailer you should:

Which part of the kingpin should the locking jaws close around?

How much space should be allowed between upper and lower fifth wheel after coupling?

You have pushed the trailer air supply valve. You should not back a tractor under a trailer until the whole air system is:

You are coupling tractor to a semitrailer. You have connected the airlines. Before backing under the trailer you should:

You are coupling a tractor to a semitrailer and have backed up but are not under it. What should you hook up before backing under?

Tractor with _____ trailer requires the shortest amount of stopping distance

After you have coupled the trailer you should have to raise the landing gear by using:

You supply air to the trailer tanks by:

Why should you be sure that the fifth wheel plate is greased as required?

When connecting the glad hands press the two seals with the coupler together at what degree to each other?

Which of these statements is true?

Why should you lock the tractor glad hands to each other (or dummy couplers) when you are not towing a trailer?

When backing a tractor under a trailer you should:

After the trailer has been coupled to the tractor, the tractor protection control valve should be placed in what position?

The fifth wheel locking lever is not locked after the jaws close around the kingpin. This means that:

Off-tracking or cheating causes of which of these to follow the wider pass while making a turn?

The iron trailer supports are up and the trailer is resting on the tractor. Make sure:

When you are uncoupling a loaded trailer you should lower the landing gear until it:

What will happen if the air lines are crossed when you hook up to an old trailer?

To stop a trailer skid you should:

If you cannot make a turn without entering another traffic lane:

The air lines on a combination vehicles are often colored to prevent then from mixing up. The emergency line is________, the service line is________.

The air leakage rate for a combination vehicle (engine off, brakes on) should be less than ______ psi per minute.

Compared to a straight truck or bus there are______ things to inspect in combination vehicle

When checking the trailer emergency brakes the tractor protection control valve should be placed in what position?

While checking if the trailer is securely coupled to the trailer the landing gears should be:

Air and electrical lines from the tractor to the trailer should be:

You have a major leak in the service line and you put on the brakes. Service air will escape and cause the:

A tractor with a _______ trailers requires the shortest amount of stopping distance.

When you get ready to back under a semitrailer you should line up:

After you lock the kingpin into the fifth wheel, you should check the connection by:

When should you use the hand valve to park a combination vehicle?

You have coupled with a semitrailer. Where should you put the iron trailer supports before driving away?

The safety catch for the fifth wheel locking lever must be _______ for a coupling to be complete.

After you supply air to the trailer, make sure the air lines are not crossed and the trailer brakes are working. This is done by:

Before you back under a trailer, make sure that:

How should you test the tractor-semitrailer connection for security?

The front trailer supports are up and the trailer is resting on the tractor. Make sure:

To unlock the fifth wheel the locking lever should be placed in the _______ position.

The tractor protection valve will close and the trailer emergency brakes will come on when there is a major leak in the ________ brake line.

When coupling, the proper position of the fifth wheel is:

What gear should the tractor engine be in after you uncouple the trailer and are inspecting the trailer supports?

When uncoupling the trailer, after you shut off the trailer air supply and lock the trailer brakes, you should:

You are driving a combination vehicle when the trailer breaks away, pulling apart both air lines. You expect the trailer brakes to come on and